Modify The Battery Capacity - ADJ WIFLY PAR QA5 User Manual

M O D I F Y T H E B AT T E R Y C A PA C I T Y
1. After replacing either the PCB or the battery, you must perform the following steps to initialize
the unit. If the unit is not initialized after replacing either of these parts, the unit battery life will be
inaccurate in future use.
2. Make sure the unit is unplugged from any power source. Switch OFF the BATTERY switch and
switch ON the LOAD switch. Press and hold the DOWN button.
3. While pressing the DOWN button, plug the unit into an AC power source. The unit should display
"-002". Release the DOWN button, and the unit displays "StAr".
4. Simultaneously press the UP & DOWN buttons and release them. "-rUn" should be displayed. This
indicates that the unit has entered the battery capacity modification mode successfully. All LEDs will
be off.
5. Switch ON the battery switch to charge the battery.
Note: Do not unplug the power cord during charging, otherwise the unit's battery life display will
be inaccurate in future use. All buttons will be useless during charge time.
6. When the LEDs are full on, the battery has reached its full charge. Unplug the power cord immediately,
and LEDs will stay full on in this status. The battery will begin to discharge.
7. Unplug the power cord and switch ON the LOAD switch. Set the unit to Static Color mode. Use the
UP or DOWN buttons so that the display shows "CL 15" (RGBA color full on) to fast discharge the
battery. Discharge the battery so that the display shows "b000". This means the battery charge is
gone. The unit has now been initialized successfully. Go ahead and recharge your battery.
24