Initialize The Unit - ADJ WIFLY PAR QA5 User Manual

I N I T I A L I Z E T H E U N I T
After replacing either the PCB or the battery, you must perform the following steps to initialize the unit.
If the unit is not initialized after replacing either of these parts, the unit battery life will be inaccurate in
future use.
1. Make sure the unit is unplugged from any power source. Switch OFF the BATTERY switch and
switch ON the LOAD switch. Simultaneously, press the MODE, SET UP, UP, & DOWN buttons.
2. While pressing these buttons, plug the unit into an AC power source. The unit should display "-002".
Simultaneously release all four buttons. The unit should display that last running mode. This indicates
that the unit has entered initialization mode successfully.
Note: When the four buttons have not been pressed simultaneously, and then you release the
buttons, 1 of 2 situations will occur which will let you know that you have not entered the
initialization mode successfully.
1. When plugging the unit into a power source, the display reads "1234". You have not entered the
initialization mode.
2. When plugging the unit into a power source, the display reads "-002", but when you release the
buttons simultaneously, the display reads "StAr", instead of the last running mode. You have not
entered the initialization mode.
3. After you have started the initialization mode, switch LOAD switch to OFF and switch ON the battery
switch. Doing this will fast charge the battery to full status. Once you have reached full charge the
display will show "b100".
4. Unplug the power cord and switch ON the LOAD switch. Set the unit to Static Color mode. Use the
UP or DOWN buttons so that the display shows "CL 15" (RGBA color full on) to fast discharge the
battery. Discharge the battery so that the display shows "b000". This means the battery charge is
gone. The unit has now been initialized successfully. Go ahead and recharge your battery.
23