Table of Contents
Advertisement
W i F l y P R I M A R Y- S E C O N D A R Y C O N F I G U R AT I O N
This feature will let you link units to run in a primary-secondary mode without the use of XLR cables.
NOTE: The ADJ RFC control must be set to OFF on all the units to use this function. See page
14 to turn OFF ADJ RFC.
1. Follow the instructions on page 14 to set the Wireless address. The addresses on each fixture must
be the same.
2. After you have set the WiFly address, select your primary unit and set your desired operating mode.
3. Put the antenna in either a up position or down position then turn the WiFly On, using the WiFly
power switch.
Note: All antennas must be in the same position, they must either be all up or all down, but never at an
angle.
4. For the Secondary units, put the unit in Secondary mode. See page 15 Primary-Secondary
configuration when setting the unit as a Secondary. Then switch ON the WiFly power switch.
5. If everything is set up correctly, the Primary units WiFly status LED will glow orange, and the
secondary units Wireless status LED will glow green.
NOTE: If they do not sync up primary-secondary, switch the Primary fixtures WiFly power switch
off then on again.
A D J R F C O P E R AT I O N
The ADJ RFC remote (sold separately) has many different functions and al- lows you to control your
WiFly Par QA5 from long distance. The ADJ RFC remote can control your system up to 150 ft. To use
the RFC you must first activate the fixtures receiver.
BLACKOUT - Pressing this button will blackout the fixture. Press this button for more then 3 seconds
to return to default settings.
AUTO RUN - This button will run an automatic program. There are 3 Auto Run programs to choose
from. Each press of the button will switch between the different modes. You can control the speed of the
Auto Run modes by pressing the SPEED button and then pressing the "+" and "-" buttons.
•
AFXX = Color Fade mode, there are 16 Color Fade modes to choose from. Use the UP or DOWN
buttons to scroll through the different Auto Fade modes.
•
AJXX = Color Change mode, there are 16 Color Change modes to choose from. Use the UP or
DOWN buttons to scroll through the different Auto Change modes.
•
A-JF = Both Color Fade and Color Change modes running.
PROGRAM SELECTION - This button will activate Static Color mode. Use the "+" or "-" to scroll
through the 15 colors. Once you have found
strobing and use the "+" or "-" to adjust the Flash rate.
FLASH - This button will activate the flash (strobe) effect. You can control the flash speed by pressing
the "+" and "-" buttons.
SPEED - Press this button and use the "+" & "-" buttons to adjust the speed of the Auto run mode.
SOUND ACTIVE - This button activates sound active mode. Use the "+" or "-" to choose from 1 of 16
sound active modes. Press this button again to enter sound sensitivity adjustment. Use the "+" or "-"
buttons to adjust the sound sensitivity.
R G B W/A - Press either one of these buttons and the press the "+" or "-" to adjust the brightness.
Press the FLASH button to activate strobing and use the "+" or "-" to adjust the Flash rate.
"+" and "-" - Use these buttons to adjust the flash rate, speed of the Auto Run mode, Auto Run program
selection, sound sensitivity, and color select.
your color, you can press the FLASH button to activate
17
Advertisement
Table of Contents
