Battery Status & Charging; Photometric Chart - ADJ WIFLY PAR QA5 User Manual

B AT T E R Y S TAT U S & C H A R G I N G
Battery Status:
This function is used to check the life status of the battery. Plug the fixture in and press the MODE
button until "bXXX" is displayed. "XXX" represents an number between "000" and "100". The number
that is displayed is the remaining battery life. If "b---" is displayed, it means the battery is dead or you
are running the unit on AC power. Please do not let the battery fully discharge as this severely
shortens battery life.
Example: If "b050" is displayed, the battery is at half life. If "b025" is displayed, the battery is at 25% life.
NOTE that when the battery is charging, or battery life is below 30%, the digital display will flash.
NOTE that after 20 seconds of inactivity, the display will revert back to the battery life display.
Battery Recharge: To recharge the battery, plug the supplied AC cord into the AC input on the side of
the unit and plug the other end into a matching power supply. It takes about 9 hours to reach full charge.
The display will STOP flashing when the unit reaches 100% charge.
Note that when unplugging the unit from charging, and then applying power via battery, there
will be a minimal charge drop.
For a faster recharge, put the Load Switch in the "Off" position and the Battery Switch in the "ON" position.
P H O T O M E T R I C C H A R T
20