Welder (If Equipped); Cold Weather Start (If Equipped); Arctic Weather Package (If Equipped) - Skyjack SJ85 AJ Operating Manual

Optional Equipment and Attachments

3.5-4 Welder (if equipped)

The welder is installed on the platform. Refer to the
welder's operating manual for proper operation and
maintenance.
Figure 20 Welder
7
Welder - This equipment is plugged into its
1
dedicated AC outlet on the platform.
7
Welder AC outlet - This AC outlet is dedicated
2
for the welder.
NOTE
In sub-zero temperatures, the hydraulic oil should
be warmed, prior to operating the welder.
WARNING
Only qualified/competent persons should install,
operate, maintain and repair the welder.
CAUTION
Breathing welding fumes and gases can be
hazardous to your health.
SJ85 AJ

3.5-5 Cold weather start (if equipped)

The battery warmer/hydraulic oil heater cord is
located in the engine compartment near the engine.
1
2
1
Figure 21 Battery warmer/Hydraulic oil heater cord
7
Battery warmer/Hydraulic oil heater cord -
1
This cord is plugged into the AC outlet at least 4
hours before starting engine when temperature
gets below -10°C (+14°F).
3.5-6 Arctic weather package (if
equipped)
The heater plug is located in the engine compartment
near the engine.
1
7
Battery/Hydraulic oil/Engine oil heater plug -
1
This cord is plugged into the AC outlet at least 4
hours before starting engine when temperature
gets below -18°C (0°F).
Section 3 – Familiarization
Figure 22 Heater plug
213217AAA
35