Locking The Turret; Lifting - Skyjack SJ85 AJ Operating Manual

Section 6 – Additional Procedures

6.5-2 Locking the turret

1. Ensure that turret is positioned so that turret
transportation lock tube
aligned into one of two turret locking points on
the chassis.
2. Lift turret lock retaining pin
32) and rotate 90 degrees. Lower turret lock
retaining pin into locked position.
Figure 33 Turret transportation lock

6.5-3 Lifting

1. Rotate the boom and position the MEWP as
shown in Figure 35.
transportation
locking point
transportation
locking point
Figure 34 Turret transportation locking points
213217AAA
74
(item – Figure 32) is
2
(item – Figure
1
1
2
Turret
Turret
5"
C L
(12.7 cm)
Figure 36 Center of gravity
2. Turn main power disconnect switch to off
position.
3. Clear platform of all personnel, tools and
materials.
WARNING
When lifting the MEWP , lifting devices must be
attached to designated lifting points only (refer to
Figure 34).
WARNING
Use chains with load capacity sufficient to
withstand MEWP weight. Refer to the serial plate
of the MEWP for specific weight.
4. Properly adjust rigging to ensure MEWP remains
level during lifting. See Center of gravity location
(Figure 35).
Figure 35 Lifting points
Loading/Unloading
SJ85 AJ