Automation Dr. Nix QNix 9500 Operation Manual page 29

Delete all measurements in an area
Select „Erase measurements" and press OK to confirm. A confirmation message will appear.
•
• Use the
Notice! A confirmation will not appear, the measurements in the selected area have been
erased.
• If necessary, enable the selected area and repeat the measurement.
Delete entire area
Select „Delete area" and press OK to confirm. A confirmation message will appear.
•
• Use the
Notice! A confirmation will not appear, if the selected area has been deleted. The numbering
will not change.
4.8. Configure Limits
You can change the limit parameters in the „Limits" menu. You can configure a different limit set for each
area..
Notice Edit limits
You can only change the limit set and the limits if there currently are no measurements. The function
is disabled if any measurement has been carried out. You can configure the limit set and the parame­
ters if no area is active, presumed there are no measurements.
• Open the „Limits" menu.
Select the desired limit set and press OK to enable.
•
Adjust all limits and press OK to apply.
•
• Close the limit set with Q or press the
directly to the measurement display.
and buttons to confirm
and buttons to confirm
Example: Limit menu for QNix® 9500P+
, then press OK to confirm
or cancel
, then press OK to confirm.
or cancel
button to go
29