Automation Dr. Nix QNix 9500 Operation Manual page 25

To exit the focus frame, press the.
4.4. Adding Jobs (QNix® 9500P+)
Depending on the mode, measurements are stored in jobs and areas:
Memory
Number of jobs
Number of areas per job
Number of spots per area, max.
Max. memory number of spots
Both the QNix® 9500B and QNix® 9500P only off er one job.
The following description only applies to QNix® 9500P+:
• Open the „Jobs" menu. If there is more than one job, the job the enabled area is under will be
highlighted. You can now
• press „Add job" to add a new job. This adds a new job to an area. The settings of the
currently enabled area will be applied.
• or select a job and „Save as new job". The selected job will be copied. The settings for the
areas will be applied..
Notice Job templates
If you have created templates for jobs in the QN9 software and uploaded these to the handheld
unit, you will be able to use the function „Create job from template". You can select the respective
template. The defined names for job and areas will remain stored.
button
QNix® 9500B
1
1
10 000
10 000
QNix® 9500P QNix® 9500P+
1
100
10 000
1 000 000 2 000 000
100
100
10 000
25