Installing a New Deuterium Lamp
Thermo Scientific
Figure 51. Deuterium lamp parts
Deuterium lamp
lead
3. Remove the two thumbscrews with standoffs that hold the lamp assembly in place and
pull the assembly straight out.
To install a new deuterium lamp
1. Remove the used deuterium lamp as described in
page
50.
2. Hold the deuterium lamp assembly so that the leads are at the top.
3. Slide the assembly onto the alignment pin (see
3
Routine Maintenance
"Removing the Deuterium Lamp"
Figure
52).
Accela UV/Vis Detector Hardware Manual
Lamp Maintenance
Thumbscrews
Deuterium lamp
on
51