Thermo Scientific Accela UV/Vis Plus Hardware Manual page 40

2
Installation
Installing the Standard Analytical Flow Cell
24 Accela UV/Vis Detector Hardware Manual
screwdriver (supplied), secure the photodiode assembly with the two mounting
screws (see Figure 30).
Figure 30. Photodiode assembly in place
d. Secure the tubing with the tubing clamp (see
Figure 31. Tubing secured with tubing clamp
Tubing clamp
e. Position the standard analytical flow cell cover over the flow cell assembly, routing the
tubing through the slots in the left side of the cover, and secure the cover with the
10-32, 0.75 in. diameter × 0.5 in. length thumbscrew fS in the accessory kit
(see Figure 32).
Photodiode
mounting
screws
Figure 31).
Thermo Scientific