Om2000A+ Remote Control - OM POWER OM2000A+ Manual

Double click on the new usb adapter line to open the configuration window for this COM port .
Set all parameters in the configuration window according to the picture below.
Check that ENABLED is selected in both associated USB windows.
Close both windows. The OM2000A+ will now follow the Band and Frequency changes on the Flex
6XXX.
7.4.

OM2000A+ Remote Control

The OM Power team has developed special software which allows controlling the PA OM2000A+
remotely. Download it from the official OM Power website http://www.om-power.com/downloads. The
software allows the following controls:
Switch the PA ON and OFF
•
Switch between STBY and OPERATE
•
Switch between preprogrammed antennas
•
Read and reset the last 20 warnings and fault messages
•
Manual fine tuning of the PA Tune and Load
•
To check most operating parameters of the PA
•
Selection of different screens for the PC display
•
Antenna retuning if parameters changed
•
Have a look on the next pictures and follow instructions to setup remote control properly.
38