OM POWER OM2000A+ Manual page 15

We recommend using the CAT connection whenever possible because, in such a case, the OM2000A+
has permanent information about the transmit frequency and is immediately ready for transmitting.
With a setting of NO CAT the OM2000A+ detects transmit frequency from the input signal. With the
input signal frequency changing the PA automatically reacts and tunes itself to optimal output
parameters. If NO CAT is used, we recommend using BAND DATA (BCD) information for much faster
.
band changing
Screen shows settings possibilities for
CAT, ANTENNA, DISPLAY, NETWORK
Type of supported TCVR and
SETTING, EBS, BLOWER and other
INFO.
frequency are visible on the
Scroll to CAT SETTINGS (up or down
press SET.
AUTO LED is ON.
Scroll to your TCVR family (up or down)
select appropriate bit rate (left or right)
Type of supported TCVR and
then press SET.
frequency are visible on the
Or select NO CAT and press SET.
AUTO LED is ON.
If you choose YAESU or ICOM NEW,
Type of supported TCVR and
after SET pressing you will go to deeper
level which allows you to select specific
type of TCVR.ee the following picture for
frequency are visible on the
ICOM NEW selection, for example.
AUTO LED is ON.
m
working
display.
working
display.
working
display.
15