OM POWER OM2000A+ Manual page 26

Go to SET EBS1 AUTO and press SET.
Type of supported TCVR and
PA will automatically set 20mA of EBS.
You can try to do this manually, too.
frequency are visible on the display.
Scroll to SET EBS1 MANUAL and press SET.
Use up/down buttons to set 20mA or as close
AUTO LED is ON.
as possible value and press SAVE.
Similar ways EBS2 can be preprogrammed
(300mA by AUTO set).
Type of supported TCVR and working
Or another value of EBS2 by MANUAL Set.
frequency are visible on the display.
Scroll to CALIBRATION Ip, Is and press SET.
Calibration will be done automatically.
Type of supported TCVR and working
Scroll to SWR PROTECT and press SET.
frequency are visible on the display.
This feature allows user to switch OFF the
SWR This feature allows the user to switch
OFF the SWR protection.
Type of supported TCVR and working
We recommend to set it ON (SWR protection
frequency are visible on the display.
circuit will stay active, max. allowed SWR is
3:1). If OFF is selected, higher SWR is
allowed, but reflected power is measured. If it
exceeds 350W, transmit will be blocked.
Press EXIT.
working
AUTO LED is ON.
AUTO LED is ON.
AUTO LED is ON.
26