OM POWER OM2000A+ Manual page 48

At the end you will return to the main screen of OM2000A+. Switch PA OFF, disconnect the
TCVR serial cable and you are ready to use the OM2000A+ with the new firmware.
Press the SEND TO LINE button.
Type of supported TCVR and
frequency are visible on the
AUTO LED is ON.
Press LOAD on the OM2000A+ to start
loading.
Type of supported TCVR and
frequency are visible on the
You can see the loading progress on
AUTO LED is ON.
the bar graph
Type of supported TCVR and
frequency are visible on the
You will see this screen after the
AUTO LED is ON.
firmware was successfully loaded
Usually, it takes about 30 seconds but
sometimes it might take a little bit
longer. Type of supported TCVR and
NOTE: Do not take any action until
frequency are visible on the
this screen disappears!
AUTO LED is ON.
working
display.
working
display.
working
display.
working
display.
48