ProMinent DULCOMETER Assembly And Operating Instructions Manual page 28

Assembly and installation
Fitting the DULCOMETER
NOTICE!
Ribbon cable base
The base for the ribbon cable is firmly soldered onto the PCB. The base cannot
be removed. Open the base lock (3) to loosen the ribbon cable, see Fig. 8
Fig. 8: Loosening the ribbon cable
1.
Undo four screws and open the DULCOMETER
2. Open the right and left lock (3) (arrows) on the base and pull the ribbon cable (1)
out of the socket
3. Use pliers to break off the catches (2 and 4). These are not needed for control
panel installation
28
Compact Controller into the cut-out in the control panel
®
1.
2.
4.
® Compact Controller
3.