ProMinent DULCOMETER Assembly And Operating Instructions Manual page 100

Replacing spare part units
Fit the cable and threaded connectors
9. Guide the cable into the respective
reducing inserts
10. Insert the reducing inserts into the
threaded connectors
11. Guide the cable into the controller
12. Connect the cable as indicated in
the terminal diagram
13. Screw in the required threaded con‐
nectors and tighten
14. Tighten the threaded connector
clamping nuts so that they are prop‐
erly sealed
Refit the controller
100
1.
Fig. 53: Fitting the profile seal on the
lower part of the controller housing
15. Use pliers to break off the catches.
They are not needed for control
panel installation
Position the profile seal evenly
around the top edge of the lower
part of the DULCOMETER
pact Controller housing. Arrange
the flaps (1) as shown in the figure
ð Ensure that the profile seal
evenly surrounds the top edge
of the housing.
16. Insert the lower part of the
DULCOMETER
troller housing with the profile seal
from behind into the cut-out and
use three screws to secure it in
place
A0360
1.
Fig. 54: Fit the profile seal onto the top
part of the controller housing
17. Position the profile seal (arrow)
evenly into the groove in the top
part of the DULCOMETER
pact Controller housing. Arrange
the flaps (3) as shown in the figure
18. Secure the strain relief (2) using
two screws (1)
19. Fit the hinge
Com‐
®
Compact Con‐
®
2.
1.
Com‐
®
A0351