Directed VW02 Firmware Specific Manual page 27

Push-To-Start type
Please ensure that the vehicle is in a safe location an cannot move
1
forward during programming. For vehicles equipped with a manual
transmission, make sure the gearshift lever is in the neutral position.
Connect all the harnesses to the Directed Digital System, EXCEPT the
2
white12-pin main power harness.
Connect the white12-pin main power harness, and wait until the LED turns
3
ON solid red.
4
Press the Unlock button on the OEM remote.
5
Make sure the key is inside the vehicle.
Important: Do NOT press the brake pedal.
6
Press the Push-to-Start (PTS) button once to turn the ignition ON. The LED
flashes green.
The green LED turns ON for 3 seconds and shuts off once the module is
7
successfully programmed.
8
Press the Push-to-Start (PTS) button once more to turn the ignition OFF.
Pair remotes (if applicable). For information on how to pair a specific
remote, please refer to its corresponding owner documentation, which
9
can be found inside the product packaging of the complete system or on
www.directechs.com.*
By default, the tachometer is preprogrammed for the vehicle. For
10
instructions on how to program tach, refer to the Analog Installation
Guide, which can be found on www.directechs.com.
* Your aftermarket remote may differ from the model shown in the illustrations.
27
Connect all but the
white 12-pin harness
Must be connected LAST
&
Key Inside
the Vehicle
Do NOT press
the brake
pedal
PUSH x1 &
&
Solid x3 secs
PUSH x1
Pair
remotes*
Initialize
tachometer
Directed Digital System VW02
© 2016 Directed. All rights reserved.
Solid
Flash
OFF