Quick Reference Guide – Autostart (Regular Key)
Vehicle takeover with Get In and Go
Close the vehicle doors, hood and trunk, then
1
press the Remote Start button on the transmitter to
start the vehicle.*
2
Press the Unlock button on the transmitter.*
Complete the following steps within 45 seconds or the vehicle will shut down.
Enter the vehicle and turn the key into ON
3
position.
Depress the brake pedal, put the car in gear and
4
drive off.
* Your key may differ from the model shown in the illustrations.
14:36
Press Unlock on
OR
either remote*
Key OUT
Key IN
Key IN
START
START
Ready to
drive off
Manual transmission ready/idle mode sequence
While the vehicle is running, put the gear in
1
Neutral (N).
2
Depress the vehicle's foot brake.
Apply the emergency brake twice (2), then release
Press Remote
Start button*
the vehicle's foot brake and skip to step 5.
OR
3
14:36
Apply the emergency brake, then release the vehicle's
foot brake.
Warning!
Depressing the brake pedal again after this
step will disable the remote start feature.
Key IN
START
START
Within 10 seconds, press any button on the
4
transmitter.*
The parking lights flash 5 times confirming that the
remote start feature is active.
5
Note: If the parking lights do not flash 5 times, you
have not entered manual transmission sequence and
will need to repeat steps 1 to 5.
Turn ignition OFF and remove the key from the
6
ignition barrel.
7
Exit the vehicle.
Press the:
•
Lock button on the transmitter* to shut the vehicle
8
Off and lock the doors.
•
Trunk button on the transmitter only to lock the
doors and enter idle mode.
* Your key may differ from the model shown in the illustrations.
Put
gear in
Neutral
Depress
brake
pedal
&
Apply emergency
Release
brake x1
OR
2
brake pedal
14:36
Press any
button*
Parking lights flash x5
Key OUT
Key IN
START
Exit vehicle
OR
14:36
Press Lock to shut vehicle Off
or Trunk (aftermarket remote
only) to enter idle mode
Directed Digital System VW02
© 2016 Directed. All rights reserved.
Need help?
Do you have a question about the VW02 and is the answer not in the manual?
Questions and answers