Directed Directechs DB3 Installation Manual
  1. Manuals
  2. Brands
  3. Directed Manuals
  4. Automobile Accessories
  5. Directechs DB3
  6. Installation manual

Directed Directechs DB3 Installation Manual

All-in-one door lock and override module
Hide thumbs Also See for Directechs DB3:
Table of Contents

Advertisement

Quick Links

See also: Installation Manual
INSTALLATION GUIDE
DB3
2009 Toyota RAV4. 403.TL11 1.06
Designed by Installers for Installers
© 2018 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.

Advertisement

Table of Contents
loading

Related Manuals for Directed Directechs DB3

Summary of Contents for Directed Directechs DB3

  • Page 1 2009 Toyota RAV4. 403.TL11 1.06 Designed by Installers for Installers © 2018 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s...

  • Page 2: Table Of Contents

    Contents Introduction Vehicle function compatibilities Pre-installation and application warnings Key type Wiring diagram Locating components in the vehicle Vehicle connections Connecting the module Module programming With transponder and CAN With transponder without CAN No transponder with CAN LED diagnostics and troubleshooting Soft reset Hard reset Feature programming...
  • Page 3 The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.

  • Page 4: Introduction

    Factory Alarm Trigger Monitoring Driver Priority Unlock Brake Status (foot brake) Immobilizer Bypass-Data No Key Req'd E-Brake Status Remote Start Takeover Ignition Status Tach / RPM Output Entry Monitoring ALL Door Pins 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 5: Pre-Installation And Application Warnings

    For vehicles with H-stamped keys, see For vehicles with G-stamped keys, see For vehicles with dot-stamped keys, the TL10 firmware. the TL5 & TL7 firmware. see the TL11 firmware. 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 6: Wiring Diagram

    9: Pink: (+) Ignition Input RX: Orange/Black: 11 Dash Fuse Box Transponder Key Amplifier Ignition Switch (white 1-pin conn.) (black conn. around ignition) Refer to Vehicle connections for wire and connector details. 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 7: Locating Components In The Vehicle

    Locating components in the vehicle 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 8: Vehicle Connections

    H2/11 Orange/Black Immo Data Transponder Key Amplifier on key switch, black 7 pin plug, pin data pink H2/12 Blue/Red (-) W2W Only - Hood Output Remote Starter 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.
  • Page 9 (Data) TX H4/2 Black (-) Ground H4/3 Green (Data) RX H4/4 (+) 12 Volt RF 2-pin white connector (H5) Module Conn./Pin Color Description H5/1 No Connection H5/2 No Connection 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.
  • Page 10 8 pin plug, pin 1 white Starter ignition switch, white 8 pin plug, pin 8 yellow Tachometer data link connector, white 16 pin plug, pin 9 gray Trunk/Hatch Release (locks/unlocks along with doors) 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 11: Connecting The Module

    4-pin D2D harness. (12-pin) (D2D) (10-pin) (14-pin) W2W installation If required: Connect the 10-pin and 12-pin harnesses to the module, then connect the 14-pin harness to the module. (12-pin) (10-pin) (14-pin) 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 12: Module Programming

    ON solid for 3 secs then shuts OFF. The module is now programmed. Remove the key from the ignition barrel. You have successfully completed the module programming sequence. 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 13: With Transponder Without Can

    LED turns ON solid orange for 3 seconds then turns OFF. The module is now programmed. Remove the key from the ignition barrel. You have successfully completed the module programming sequence. 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 14: Led Diagnostics And Troubleshooting

    Flashes red x 7 Bypass and CAN were skipped. The programming button was pressed 5 times to skip bypass, and 5 times to skip CAN. Flashes red x 8 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.
  • Page 15 The smart key was not detected, which prevents the system from shutting down the vehicle. Flashes red x 3 Speed was detected. The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 16: Soft Reset

    Wait 3 seconds until the LED turns ON solid orange, and wait 10 more seconds until the & LED starts to flash orange and red. Solid Flashes Release the programming button. The LED turns ON solid red. & Release Solid 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 17: Feature Programming

    To exit feature programming, press and hold the programming button for 3 seconds or ensure there is no activity on the interface for 30 seconds. The LED will turn ON orange for 2 seconds to confirm the end of the programming sequence. 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 18: Feature And Option List

    1. Trunk* Will pop the trunk if available. Trunk 2. Tail Glass Will open the tail glass if available. Opening 1. Trunk Will pop the trunk if available. Aux1 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

  • Page 19: Limited One Year Consumer Warranty

    This warranty gives you specific legal rights and you may also have other rights that vary from State to State. DIRECTED does not and has not authorized any person or entity to create for it any other obligation, promise, duty or obligation in connection with this Part.

  • Page 20: Quick Reference Guide

    Factory remote. Press the Remote Start button on the transmitter.* • Aftermarket remote. • Directed SmartStart application via your smartphone. & The parking lights will flash once to indicate the Parking lights flash x1 Press Remote vehicle is now in Pit Stop Mode.
  • Page 21 Notes 403.TL11 1.06 2009 Toyota RAV4 © 2018-12-04 Directed. All rights reserved.

Table of Contents