Assigning An Ip Address - Juniper E Series Hardware Manual

Figure 41: E-series routers management ports
SRP I/O
module
2. Connect the crossover adapter connector to your PC's serial port.
3. Power up the system.
NOTE:
system as it boots.

Assigning an IP Address

When your console is ready to communicate with the system, power up the system
(see Chapter 7, Powering Up E-series Routers), and set an IP address for the system.
The system powers up in User Exec mode. To assign an IP address:
1. Enter the enable command at the User Exec prompt.
ERX-310 Router
RS-232 port 10/100
BASE T port
CONSOLE
EXTERNAL TIMING
ERX-7xx Model
When you power up the system, the CLI appears on your console's screen. The
system is now in User Exec mode, and you can begin configuration. For more
information on using the CLI and configuring the system, see the
System Basics Configuration
Direct access through the RS-232 serial port allows you to monitor the
host1>enable
host1#
The system is now in Privileged Exec mode.
SRP I/O module
A
T1 100 OHM
CLOCK IN
B
10/100
BASE T
RS-232
ERX-14xx Model
Guide.
Chapter 8: Accessing E-series Routers
T
G
R
T
G
R
10/100
BASE T port
RS-232 port
JUNOSe
Console Port Setup
! 79