Test Details - Xilinx ZCU106 Manual

Test Details

Ensure that you have followed all instructions in XTP497, ZCU106 Software
˃
Install and Board Setup
Ensure that no other Terminal program is connected to the ZCU106's COM
˃
ports while the Board Interface Test is running
See XTP497, for details on COM Ports
Only one board can be connected to your PC during the test
˃
Both USB UART (J83) and USB JTAG (J2) are required for this test
Disconnect any other board UARTs or Programming Cables
If you missed any set-up instructions and experience problems, then please
˃
follow these steps:
Recheck your setup
End any hw_server processes and cycle board power
Open Vivado Hardware Manager and test PC-board JTAG connectivity
Note: Presentation applies to the ZCU106