Oil Filter - Can-Am OUTLANDER 6x6 2021 Series Operator's Manual

MAINTENANCE PROCEDURES
Engine Oil Change
CAUTION The engine oil can
be very hot. Wait until engine oil is
warm.
NOTICE
Engine oil and oil filter
must be replaced at the same time.
Bring engine to its normal operating
temperature.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the oil drain plug area.
Place a drain pan under the oil drain
plug area.
Unscrew oil drain plug.
vmo2012-012-058_a
1. Drain plug
Allow enough time for oil to flow out of

oil filter.

Replace the oil filter. Refer to
TER
.
Change gasket on oil drain plug.
Clean gasket area on engine and oil
drain plug then reinstall plug.
Refill engine at the proper level with
the recommended oil.
SPECIFICATIONS
Refer to
pacity.
Start engine and let idle for a few min-
utes.
Ensure oil filter area and oil drain plug
areas are not leaking.
Stop engine.
______________
126
Wait a while to allow oil to flow down to
crankcase then check oil level.
Refill as necessary.
Dispose of oil as per your local environ-
mental regulations.
Oil Filter
Oil Filter Removal
To reach oil filter, remove the following
parts:
– Seat
– Console
– RH side panel
– RH footrest panel.
1. Clean oil filter area.
2. Remove oil filter cover screws.
3. Remove oil filter cover.
4. Remove oil filter.
tmr2011-010-004_a
OIL FIL-
1. Oil filter screw
2. Oil filter cover
3. O-ring
4. Oil filter
Oil Filter Installation
1. Check and clean the oil filter inlet
for oil ca-
and outlet area of dirt and other con-
taminations.