Operator's Seat - Can-Am OUTLANDER 6x6 2021 Series Operator's Manual

1) Operator's Seat

The seat is designed for an operator
only.
WARNING
Never allow anyone to seat as a
passenger on this vehicle.
Seat Removal
To remove the operator's seat, push its
latch forward. This latch is located un-
derneath the rear of seat.
vmo2015-023-501_a
1. Seat latch
Pull seat rearward. Continue lifting
movement until you can release the
front retaining device then completely
remove seat.
Seat Installation
Insert front tabs of seat into frame
hooks. When seat rests in its posi-
tion, firmly push seat down to latch.
NOTE: A distinctive snap will be felt.
Double check that the seat is secure by
giving it a tug to confirm proper latch-
ing.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
Confirm that the operator's seat
is properly locked in position by
pulling back and up several times.
Passenger's Seat (Including
Backrest and Grab Handles)
(2-UP Models)
Never operate the vehicle without
passenger's seat.
The passenger seat is designed for one
passenger only. The backrest provides
support and grab handles allow a good
grip.
219001923-022_c
1. Backrest
2. Grab handles
3. Passenger's seat
Without its passenger's seat, the
vehicle becomes a ONE RIDER ve-
hicle (1-UP model) and NO PAS-
SENGER must be allowed on vehi-
cle.
WARNING
_______________
EQUIPMENT
WARNING
WARNING
WARNING
91