Wheel Bearing; Wheels And Tires - Can-Am OUTLANDER 6x6 2021 Series Operator's Manual

219001961-009_a
TYPICAL — FRONT OF VEHICLE
1. Drive shaft boots
2. Drive shaft protector
219001961-010_a
TYPICAL — REAR OF VEHICLE
1. Drive shaft boots
2. Drive shaft protector

Wheel Bearing

Wheel Bearing Inspection
Place vehicle on a level surface.
Apply the parking brake.
Lift and support vehicle.
Secure vehicle on jack stands.
Push and pull the wheels from the up-
per edge to feel the play.
See an authorized Can-Am dealer if
there is any play.
While reading this Operator's Guide, remember that:
Indicates a potential hazard that, if not avoided, could result in serious
injury or death.
tmo2011-001-131_a
TYPICAL

Wheels and Tires

Tire Pressure
Tire pressure greatly affects vehi-
cle handling and stability. Under-
pressure may cause tire to deflate
and rotate on wheel. Overpres-
sure may burst the tire. Always
follow recommended pressure.
NEVER set tire pressure below
minimum. It could cause the tire to
dislodge from the rim. Since tires
are low-pressure types, a manual
pump should be used.
Check pressure when tires are cold
before using the vehicle. Tire pres-
sure changes with temperature and
altitude. Recheck pressure if one of
these conditions has changed.
For your convenience, a pressure
gauge is supplied in tool kit.
Refer to
pressure.
WARNING
______________
MAINTENANCE PROCEDURES
WARNING
SPECIFICATIONS
for proper
143