Can-Am OUTLANDER 6x6 2021 Series Operator's Manual page 131

Engine Coolant Replacement
Cooling System Draining
Remove the gauge support.
219001854-001_a
Step 1: Pull up
Step 2: Slide
Remove the coolant reservoir cap.
WARNING
To avoid potential burns, do not
remove the pressure cap if the en-
gine is hot.
vmo2012-012-042_a
1. Engine coolant reservoir cap
Unscrew the coolant drain plug and
drain the coolant into a suitable con-
tainer.
vmo2012-012-058_b
1. Coolant drain plug
NOTE: Do not unscrew the coolant
drain plug completely.
650 Models
Disconnect the lower radiator hose
and drain the remaining coolant into a
suitable container.
NOTE: Take note of the position of the
hose clamp on the lower radiator hose
at the radiator.
Reinstall radiator hose as noted prior to
removal.
All Models
Reinstall cooling system drain plug
with a new sealing ring.
Tighten the coolant drain plug to speci-
fication.
Cooling
system drain
plug
Bleed cooling system, refer to
ING SYSTEM FILLING AND BLEED-
ING
.
Cooling System Filling and Bleeding
1. Unscrew bleed screws above both
front and rear cylinders.
______________
MAINTENANCE PROCEDURES
TIGHTENING TORQUE
9 N•m to 11 N•m
(80 lbf•in to 97 lbf•in)
COOL-
129