Table of Contents
Advertisement
7.4.1 Add/ Edit MAC Addre sse s
Click
Add ne w MAC a ddre ss
new MAC address. You can also click the Edit icon next to a MAC authentication rule to edit the rule.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the WX Device in
these address fields. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
Network Setting> Wireless > MAC Authentication > Add/Edit
Fig ure 49
7.5 WPS Se tting s
WiFi Protected Setup (WPS) allows you to quickly set up a wireless network with strong security, without
having to configure security settings manually. To set up a WPS connection between two devices, both
devices must support WPS. It is recommended to use the Push Button Configuration (
wireless client supports it. See
Note: The WX Device applies the security settings of the main SSID (
7.2 on page
Note: The WPS switch is grayed out when WiFi is disabled.
Click
Ne two rk Se tting > Wire le ss > WPS
blue. Click
Apply
Chapter 7 Wireless
in the
Ne two rk Se tting
Section 7.11.8.3 on page 119
93).
. The following screen displays. Click this switch and makes it turn
to activate the WPS function. Then you can configure the WPS settings in this screen.
WX Series User's Guide
>
>
Wire le ss
MAC Authe ntic a tio n
for more information about WPS.
102
screen to add a
) method if your
PBC
) profile (see
Section
SSID1
Advertisement
Table of Contents
