Table of Contents
Advertisement
The WX3100-T0's Rear Panel
Fig ure 18
Table 4 Panel Ports and Buttons
L ABEL
LAN1/LAN2
WPS
POWER ON/OFF or DC/IN
RESET
2.3 L EDs (L ig hts)
None of the LEDs are on if the Zyxel Device is not receiving power.
Zyxel MPro Mesh router
Table 5 LED Table (for the WX Device-1)
L ED
POWER
Link (With a
WiFi
connection)
Chapter 2 Hardware
DESC RIPT IO N
Connect computers or other Ethernet devices to Ethernet ports for Internet access.
Press the
WPS
Connect the power cable and then press the power button to start the device.
Press the button to return the WX Device to the factory defaults.
C O L O R
ST AT US
Green
On
Blinking
Red
On
Blinking
Green
On
Amber
On
Red
On
WX Series User's Guide
button once within eight seconds to enable the AP/Repeater mode.
DESC RIPT IO N
Power is on or the MPro Mesh configuration process is done.
The WX Device is starting up or under the MPro Mesh
configuration process.
The WX Device detects a system error.
The WX Device is upgrading firmware.
The WiFi connection to the MPro Mesh router is good.
The signal is too strong. We suggest moving the WX Device away
from the MPro Mesh Router.
The signal is too weak. Move the WX Device closer to the MPro
Mesh Router.
23
Advertisement
Table of Contents
