Table of Contents
Advertisement
8.2 Ho m e Ne two rking Sc re e n
Use this screen to set the IP address and subnet mask of your WX Device. Configure DHCP settings to
have a DHCP server assign IP addresses to devices. Click
the
Ho m e Ne two rking
Follow these steps to configure your LAN settings.
Enter an IP address into the
1
become the IP address of your WX Device.
Enter the IP subnet mask into the
2
alone, the configurator will automatically compute a subnet mask based upon the IP address you
entered.
Click
to save your settings.
3
Apply
Network Setting > Home Networking > Home Networking
Fig ure 64
The following table describes the fields in this screen.
Table 31 Network Setting > Home Networking > LAN Setup
L ABEL
LAN IP Setup
IP Address
Chapter 8 Home Networking
screen.
field. The IP address must be in dotted decimal notation. This will
IP Addre ss
IP Sub ne t Ma sk
DESC RIPT IO N
Select
to deploy the WX Device as a DHCP client in the network. When you enable this,
DHC P
the WX Device gets its IP address from the network's DHCP server (for example, your ISP or
router). Users connected to the WX Device can now access the network (i.e., the Internet if the
IP address is given by the ISP or a router with Internet access). When you select this, you cannot
enter an IP address for your WX Device in the field below.
Select
if you want to specify the IP address of your WX Device. Or if your ISP or network
Sta tic IP
administrator gave you a static IP address to access the network or the Internet.
Enter the LAN IPv4 IP address you want to assign to your WX Device in dotted decimal notation,
for example, 192.168.1.2 (factory default).
WX Series User's Guide
Ne two rk Se tting > Ho m e Ne two rking
field. Unless instructed otherwise it is best to leave this
125
to open
Advertisement
Table of Contents
