Table of Contents
Advertisement
18.3 Ping & T ra c e Ro ute
Use this screen use ping, traceroute, or nslookup for troubleshooting. Ping and traceroute are used to
test whether a particular host is reachable. After entering an IP address and clicking on one of the
buttons to start a test, the results will be shown in the Ping/Traceroute Test area. Use nslookup to find the
IP address for a host name and vice versa. Click
next.
Maintenance > Diagnostic
Fig ure 83
The following table describes the fields in this screen.
Table 44 Maintenance > Diagnostic
L ABEL
Address
Ping
Ping 6
Trace Route
Trace Route 6
Nslookup
Chapter 18 Diagnostic
DESC RIPT IO N
Type the IP address of a computer that you want to perform ping, traceroute, or nslookup in
order to test a connection.
Click this to ping the IPv4 address that you entered.
Click this to ping the IPv6 address that you entered.
Click this to display the route path and transmission delays between the WX Device to the IPv4
address that you entered.
Click this to display the route path and transmission delays between the WX Device to the IPv6
address that you entered.
Click this button to perform a DNS lookup on the IP address of a computer you enter.
WX Series User's Guide
Ma inte na nc e > Dia g no stic
151
to open the screen shown
Advertisement
Table of Contents
