ASSEMBLY
DRIVELINE CLAMP YOKE OPERATING INSTRUCTIONS
Depending on if the yoke on the driveline consists of (1) or
(2) bolts, start by removing the 5/8" bolt(s) from the driveline
clamp yoke and slide yoke onto the shaft and align holes
with annular groove of gearbox shaft. Reinstall bolt(s) and
tighten to 150 ft-lb torque. Push and pull the driveline to
ensure it is securely attached to the shaft. Regularly check
the driveline yoke to ensure a tight connection. To remove
the yoke, remove the bolt(s) and pull yoke off the shaft. A
two bolt yoke is shown in Figure Asm-R-0472. Mower is
now assembled and ready for pre-delivery checks.
WHEELS
Install the Wheels on the Wheel Hubs.
Note: If Laminated Tires are used, place the flat side of the Lug Nut against the Wheel.
Note: the direction of travel and curvature of rubber segments in tire and install as shown in FIGURE Asm-R-
0127
TR308 04/21
Assembly Section 3-8
@ 2021 Alamo Group Inc.