To Disassemble Universal Joint - RHINO FC-0110 Operator's Manual

TO DISASSEMBLE UNIVERSAL JOINT

1. Remove all snap rings.
2. Position joint in loose vice, strike top arm of
unsupported yoke to drive the top cup up.
Repeat on opposite side.
3. If you cannot grip the loosened cap per Step
4, use a pointed tool to tip a needle them
repeat Step 2.
4. Grip loosened cup in vise, strike yoke arm to
drive yoke off cup. Repeat on opposite cup.
5. Support cross in loose vise and strike yoke
arm. Repeat Step 4 to remove remaining two
cups.
TR308 04/21
© 2021 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-11