Troubleshooting Guide - RHINO FC-0110 Operator's Manual

15. TROUBLESHOOTING GUIDE

Problem
Uneven Cut
Uncut Material
Poor Shredding
Windrowing or
Uneven
Distribution
Blade Bolts
Working Loose
TR308 04/21
@ 2021 Alamo Group Inc.
OPERATION
Possible Cause
Excessive ground speed.
Blades worn, dull or bent.
Mower not level side to side.
Improper height adjustement.
Low tractor tire pressure on one side.
Turning too fast.
Tractor tires push grass down.
Damaged Mower pan.
Excessive ground speed
RPM too low
Improper blade for direction of cut.
Excessive ground speed.
Cutting too high.
Material heavy and lush.
Excessive ground speed.
Conditions too wet.
Bolts not tighened.
Bolt hole elongated or oversized
Locknut worn out.
Operation Section 4-47
Remedy
Reduce ground speed.
Replace blades.
(Refer to "Maintenance" Section)
Adjust. (Refer to "Assembly" Section)
Adjust mower height.
(Refer to "Assembly" Section)
Adjust tire prersure. (Refer to your tractor
Operator's Manual)
Reduce ground speed when turning.
Adjust your tractor wheel spacing.
(Refer to "Operation" section)
Repair or replace as necessary.
Reduce ground speed.
Use full PTO speed. (Refer to
your tractor Operator's Manual)
Install blades so rotation is correct.
Raise the front of Mower relative to the
rear to hold and circulate material
longer. (Refer to the "Operation
Section-Setting the Mower-Setting
Deck Height") Reduce ground speed.
Lower cutting height. (Refer to the
"Operation Section-Setting the Mower-
Setting Deck Pitch")
Raise the front of Mower relative to the rear.
(Refer to the "Operation Section-
Setting the Mower-Setting Deck Height")
Reduce ground speed.
Wait for conditions to dry. Reduce ground
speed.
Tighten Bolts to 300 ft./lbs.
Replace Blade Carrier.
Replace Locknut.