RHINO FC-0110 Operator's Manual page 114

The Drivelines and U-Joints should be inspected each morning before the mower is started.
The U-Joint and CV Joint on the Driveline undergo extreme forces when the unit is turning or when the Wings
are being raised. It is important that the U-Joints and CV Joint be greased per schedule before the unit is
started. The U-Joints are located at each end of the Center and Wing Drivelines. The CV Joint is located at the
end of the Main Driveline. The U-Joint and CV Joint assemblies are accessible by rotating the Driveline Safety
Shield until the hole in the Shield matches up with the Grease Fitting. Lubricate all fittings with a good quality
Lithium Soap compatible E.P. grease meeting the N.L.G.I. #2 specifications and containing no more than 1%
Molybdenum, Disulfide. An E.P. grease meeting the N.L.G.I. #2 specifications and containing 3% Molybdenum
Disulfide may be substituted in the telescoping members only. Inspect the U-Joint for wear by holding the shaft
on one side of the U-Joint while trying to rotate the shaft on the other side of the U-Joint. If there is noticeable
movement in the Driveline replace the U-Joint before it causes severe damage to the driveline..
Location
Cross & Bearings
Telescoping Tube
Shield Bearings
End Spider Hub
CV Center Housing
TR308 04/21
© 2021 Alamo Group Inc.
MAINTENANCE
Extended Lube Interval
8 Hours
8 Hours
50 Hours
20 Hours
8 Hours
Maintenance Section 5-8
Lever Action Pumps
2 - 3
6 - 8
1 - 2
1 - 2
12 - 15