Driveline Clamp Cone Yoke Operating Instructions - RHINO FN180 Operator's Manual

ASSEMBLY

Driveline Clamp Cone Yoke Operating Instructions

Remove the two 5/8"-11 bolts from the driveline
clamp yoke and slide yoke onto the shaft and align
holes with annular groove of gearbox shaft.
Reinstall bolts and tighten to 130 ft.-lb. torque. Push
and pull the driveline to ensure it is securely
attached to the shaft. Regularly check the driveline
yoke to ensure a tight connection. To remove the
yoke, remove the bolts and pull yoke off the shaft.
Mower is now assembled and ready for pre-delivery
checks.
FN180/FN120 07/12 Assembly Section 3-9
© 2012 Alamo Group Inc.