Connecting The Mower To The Tractor; Connecting The Mower-Lift Type - RHINO FC-0110 Operator's Manual

5.CONNECTING THE MOWER TO THE TRACTOR

Use extreme caution when connecting the mower to the tractor. The mower should be securely resting at
ground level or setting on blocks.
between the tractor and mower pins. OPS-R-0001 str
Always shut the Tractor completely down, place the transmission in park, and set the parking
brake before you or anyone else attempts to connect or disconnect the Implement and Tractor
hitches.

5.1 Connecting the Mower-Lift Type

1. Make sure the tractor is equipped with the
correct PTO shaft. Change shafts if needed.
2. Shorten or remove the tractor drawbar to avoid
interference when raising and lowering the
mower.
3. Board the tractor and start the engine. Position
the tractor to the mower with the 3-point lift arms
positioned between the respective set of mower
A-frame lift lugs.
Note: Set the 3-point lift control to "Position
Control" so that the lift arms maintain a constant
height when attaching the mower. See the
tractor Operator's Manual for correct settings
when attaching 3-point equipment.
4. Turn off the tractor engine and dismount.
5. One lift arm at a time, align arm end hole
between the set of holes of A-frame lift lugs.
Insert hitch pin through the lug and arm holes
and insert retaining pin into hitch pin. Walk
around to opposite side and repeat procedure
for remaining lift arm and hitch pin.
6. Lift Mowers-Extend or retract the 3-point top
link to align its end hole with the holes of the
mower's top link. Insert the top link hitch pin and
insert retaining pin into hitch pin.
Mount Mowers-If hydraulic cylinders are being
used to raise and lower the mower or to control
an off set hitch, attach hose ends into the tractor
hydraulic ports..
7. Adjust any lower link check chains, guide
blocks, or sway blocks to prevent the mower
from swaying side to side and possible contact
with tractor rear tires.
TR308 04/21
@ 2021 Alamo Group Inc.
OPERATION
Keep hands and feet from under the mower and clear of pinch points
(S3PT-15)str
Semi-
Operation Section 4-9