To Disassemble Universal Joint - RHINO Turbo 120 Operator's Manual

IMPORTANT: Scan this QR Code with your smart phone to link to the ADMA
Driveline Safety Manual for more information on the safe use of a driveline during
normal operation and maintenance. Or type in your internet browser the following
web address: www.algqr.com/dme
TO DISASSEMBLE UNIVERSAL
JOINT
1. Remove all snap rings.
2. Position joint in loose vice, strike top arm of
unsupported yoke to drive the top cup up.
Repeat on opposite side.
3. If you cannot grip the loosened cap per Step 4,
use a pointed tool to tip a needle them repeat
Step 2.
4. Grip loosened cup in vise, strike yoke arm to
drive yoke off cup. Repeat on opposite cup.
TURBO 120 08/12
© 2012 Alamo Group Inc.
MAINTENANCE
Ops-0009-MISC
Maintenance Section 5-13