Table of Contents
Advertisement
INSTALLER GUIDE
14. REASSEMBLE OF FIRE
The parts that where removed earlier now need to be refitted;
14.1 Place the bottom tray back into the convector box
above the main burner assembly as before. Line up the
tray with the screw holes in the inner convector box and
using the screws removed earlier, secure it to the inner
convector box.
14.2 The top tray requires no screws it simply locates
flat into position on top of the base tray.
Note: if Glass liners have been fitted a decorative filler
piece is required to be fitted to the rear of the top tray to
fill the gap between the top tray and the rear glass liner.
This can be found in the accessory kit.
14.3 Positioning the ember wool across the burners.
Each fire is supplied with a single bag of ember wool
600 models (approx. 1 gram), 800 models (approx. 2
grams) and 1000 models (approx. 3 grams).
DO NOT EXCEED THE WEIGHT OF EMBER WOOL SUPPLIED.
To ensure a good effect and so as not to effect combustion this ember wool must be
placed as follows. The ember wool should be removed from the jiffy bag and teased
apart until they form a very loose, very light network avoid clumps of ember wool in
anyone section.
ONLY place the ember wool over the open burner ports. Especially along the rear
burner and towards the middle of the front burner only. The ember wool has a long
life, it will eventually deteriorate. If this becomes apparent, replacement ember wool
can be obtained by calling our customer service team.
NOTE: to avoid any ignition interference issues, keep the ember wool at least 15mm
clear of the pilot unit when positioning.
©
Page 33
GDC Group Ltd. NOV 2017
Advertisement
Table of Contents
