Operating The Fire With Slider Control (Fs) Models; Lighting The Fire; Adjusting The Flame Height; To Turn Off Using Slider Handle - Valor Inspire 1000FS Installer And Owner Manual

Slider Control models - 600FS, 800FS & 1000FS

Lighting the fire.

Push the slider handle to the LEFT as far as possible till the ignition position is
-
reached, several sparks will occur between the electrode and pilot tip. Hold in this
position till the pilot flame has heated the thermocouple sufficiently to hold.
Approx. 5 - 15 seconds.
Adjusting flame height.
When the burner is operating step the slider handle to the RHS, increments will be
felt as the slider moves giving you the following outputs;
Position 1 - After ignition Front burner is on LOW
Position 2 - Moving slider handle one increment to RHS, front burner is on HIGH.
Position 3 - Moving slider handle one more increment to the RHS, Rear burner on
HIGH ignites (along with the Front burner remaining on HIGH)
Position 4 - Moving the slider as far as possible to the RHS is OFF
Note: There is no pilot only setting on the Slider (FS) models.
Turning off.
To turn the fire off push the slider as far as possible to the RHS.
© Page 53
GDC Group Ltd. NOV 2017