Valor Inspire 1000FS Installer And Owner Manual page 6

Section
11. CONVECTION BOX INSTALLATION
11.1 Method 1 - Front fixing to fireplace surround.
11.2 Method 2 - Cable retention and floor fixing.
11.3 Sealing floor front - Method 1 & 2 inc Frameless
12. FITTING THE WALL LINERS & FUEL EFFECT
12.1A Fitting the Single piece rear wall liner (Ceramic/Glass)
12.1B Fitting the Two or Three piece rear wall liners (Vermiculite)
12.2 Fitting the Glass liners spacer support and filler piece.
12.3 Fitting the side wall liners (Vermiculite/Ceramic/Glass.
12.4 Fitting the log fuel effect
13. BURNER AND SUPPLY PIPE INSTALLATION
13.1 Burner installation.
13.2 Supply pipe installation.
13.3 Burner checks.
- 13.3.1 Lighting the fire (RC)
- 13.3.2 Adjusting flame height (RC)
- 13.3.3 Adjusting to pilot only (RC)
- 13.3.4 Turing off (RC)
- 13.3.5 Lighting the fire (FS)
- 13.3.6 Adjusting flame height (FS)
- 13.3.7 Turning off (FS)
13.4 Check inlet pressure.
14. REASSEMBLE OF FIRE
14.1 Fitting the bottom tray into convector box
14.2 Fitting the top tray into the convector box
14.3 Positioning the ember wool accross the burners
14.4 Replacing the log fuel effect
14.5 Refit the window door panel
14.5 Refit the visual baffle
15. FULL OPERATING CHECKS
15.1 Check the burner operation.
15.2 Check for spillage.
15.3 Flame supervision and spillage monitoring system.
16. TRIM OR FRAMELESS INSTALLATION
17. FINAL REVIEW
©
GDC Group Ltd. NOV 2017
CONTENTS (Continued)
Page 6
Continued on next page
Page
26
26
26 - 27
28
29
29
29
29
29
30
30
30
30
30
30
31
31
31
31
32
32
32
33
33
33
33
34
34
34
34
34
34
35
36
37