Firmware Update - Elmo TD4114 IP II Instruction Manual

• Open Snapshot Folder .......... Opens the file designated at Path on the Snapshot Setup
• Image Viewer ....................... Displays the JPEG images saved in the PC.
• Language Setup .................... Set English or Japanese for Viewer (the selection becomes
• Network Update.................... Rewrites the firmware for the Camera networked.
• Camera Control..................... Displays the camera control on the right side of the Main

(23) Firmware update

You can update the firmware for the Camera (Camera operation programs) via a network
for the purpose of improving its functions.
Since an update changes the key functions of the Camera, it may fail to get started or
malfunction if the update is not carried out correctly.
Update the firmware according to the procedure described below with extreme care.
Do not attempt to modify the firmware for firmware updating that was distributed by the
shop where you purchased the product or our branch or sales office nearby. Using another
firmware or modified firmware may cause the Camera to malfunction.
1. Turn OFF the power to the Camera, and connect it and the host one-to-one with a
cross cable.
2. Set the network for the host according to the network address of the Camera.
screen.
Displays the JPEG images in D1, which was acquired in
Half-D1.
valid after Viewer is turned OFF and ON again).
screen of Viewer.
- 70 -