Camera Control Setup - Elmo TD4114 IP II Instruction Manual

• Modifying an address
Select the address you want to modify from the list.
Change the "start address" and the "end address", and click on the [Modify] button. The
data will be corrected.
• Deleting an address
Select the address you want to delete from the list, and click on the [Remove] button.

(15) Camera Control Setup

Make settings relating to the Camera.
• User Authentication .............. When the connection is made to the Camera, select
• Control Policy....................... Designate the mode of controlling the Camera.
All-Time Share................... Constantly accepts operations from all clients.
Time Slice Share ................ The operation authority will be released as soon as the
Note: When the control is set as "Time Slice Share" in "Control Policy", it
may occur temporarily that all connectors are in the state with no
control. Since this is a phenomenon due to the state of transmission,
the normal status can be resumed in seconds to minutes.
whether the user authentication should be "Enable" or
"Disable". When "Disable" is selected, press the [OK]
button with the login ID and password left blank on the
Authentication screen displayed upon the connection.
Then, the login is enabled by the operator authority. To log
in by the administrator authority, enter the registered login
ID and password.
time set at "Control Duration Time" passes away, and will
be assigned to anther connecting client. It will remain
when there is no other connecting client.
- 42 -