Screen Saver - Kemppi MasterTig 235ACDC Operating Manual

3.3.9 Screen saver

The screen saver image shown during start-up and when the control panel has been idle for a predefined time can be
changed using the screen saver tool at kemp.cc/screensaver. To make the change, you'll need the image file you are
planning to use and a USB memory stick.
Tools:
• Screwdriver, Torx head (T20).
1. On a web browser, go to kemp.cc/screensaver.
2. Following the on-screen instructions, upload, edit and download the new screen saver image onto a USB memory
stick.
3. Detach the control panel from the power source:
>> Remove the top screw and panel cover.
>> First pull the top of the control panel slightly and then the rest of the panel.
Do not disconnect the control panel cable. The power source and control panel must be turned on.
4. Connect the USB memory stick to the USB connector on the rear side of the control panel. The control panel detects
your USB memory stick automatically and shows a list of available images.
Always connect and disconnect the USB device in a straight angle to avoid any additional stress to the USB con-
nector.
© Kemppi
MasterTig 235ACDC, 325DC, 335ACDC, 425DC
50
Operating manual - EN
1920900 / 2052