Fine Span Adjustment - Cardinal 212 Series Installation, Technical And Operation Manual

Fine Span Adjustment

Fspan?
Fine Span Adjustment (after pressing ENTER at last
F span
Fine Span Adjustment (from
8200-M639-O1 Rev D 09/14
IMPORTANT! The FSPAn (FSPAn?) mode requires a load of 10%
of Capacity on the scale before adjustments can be made.
With FSPAn? displayed, press the ENTER key.
1.
The display will change to show the current setting "no".
2.
To skip the Fine Span Adjustment and return to the SEtUP menu,
3.
press the ENTER key again.
To perform the Fine Span Adjustment, place a calibrated test
4.
weight on the scale and press the numeric key 1/YES and then the
ENTER key.
After pressing the ENTER key, the display will change to show the
5.
amount of the test weight and the annunciator display will
alternately flash off and on i.e. (all ON, weighing unit off, then all
OFF, weighing unit ON).
Press the 1/YES to increase the span OR press the 0/NO key to
6.
decrease the span.
Press the  key to return to the previous prompt or press the
7.
ENTER key to exit FSPAn? and return to the SetUP menu.
With FSPAn displayed, place a calibrated test weight on the scale and
1.
press the ENTER key.
After pressing the ENTER key, the display will change to show the
2.
amount of the test weight and the annunciator display will alternately
flash off and on (all ON, weighing unit off, then all OFF, weighing unit
ON).
Press the 1/YES to increase the span OR press the 0/NO key to
3.
decrease the span.
Press the  key to return to the previous prompt or press the ENTER
4.
key to exit FSPAn and return to the SetUP menu.
212/212X Installation & Technical
SETUP
prompt pressing the F key to advance)
Print
prompt)
Page 89