Starting The Engine - Norton Clipper C1318P Owner's Manual

3. Clean off any foreign particles on the clamping surfaces of both collars
and on the mounting surface of the blade.
4. Place the blade on the blade shaft, lining up the drive pin hole in the
blade with the drive pinhole in the inside collar.
For Best Performance Use Only Norton Diamond Blades
Specified For the Material Being Cut.
5. Slide the outside blade shaft collar onto the blade shaft. The drive pin
on the outside collar must project through the drive pin hole in the blade
and into the inside collar.
6. Tighten the blade shaft nut (counter-clockwise) securely against the
outside collar.
7. Reconnect the spark plug.
B. Starting the Engine
1. Refer to the engine owner's manual for detail starting procedures.
2. Always cut with engine rpm in the full throttle setting.
Before starting, insure that the blade is properly installed,
all guards are in place and in safe operating condition, and
that the Blade is not in contact with any surface or object.
Also verify that the area where the work is to be preformed
is clean, safe, and has proper ventilation and lighting.
Always located and properly mark all water, gas, and
electrical services before beginning any work.
10