Starting The Engine; C1318P 13Hp Honda - Norton Clipper C1418P Owner's Manual

3. Clean off any foreign particles on the clamping surfaces of both collars
and on the mounting surface of the blade.
4. Place the blade on the blade shaft, lining up the drive pin hole in the blade
with the drive pinhole in the inside collar.
For Best Performance Use Only Norton Diamond Blades Specified
for the Material Being Cut.
5. Slide the outside blade shaft collar onto the blade shaft. The drive pin on
the outside collar must project through the drive pin hole in the blade and
into the inside collar.
6. Tighten the blade shaft nut (counter-clockwise) securely against the
outside collar.
7. Reconnect the spark plug.
B. Starting the Engine
Starting the C1318P 13HP Honda
1. Refer to the engine owner's manual for detail starting procedures.
2. Always cut with engine rpm in the full throttle setting.
Before starting, insure that the blade is properly installed,
all guards are in place and in safe operating condition,
and that the Blade is not in contact with any surface or
object. Also verify that the area where the work is to be
performed is clean, safe, and has proper ventilation and
lighting. Always located and properly mark all water, gas,
and electrical services before beginning any work.
C1318P Honda Powered
Move the Fuel Control to the ON Position
C1318P Honda Powered
C1318P Honda Powered
Move the choke lever to the CLOSED position.
NOTE: do not use the choke if the engine is warm or
the air temperature is high.
C1318P Honda Powered
10