Assembly - Norton Clipper C1318P Owner's Manual

I. PREPARATION
B. Assembly
The compact concrete saws are shipped completely assembled and ready for
use except for diamond blade, gasoline, oil, and handle bar. Inspect the saw
for shipping damage. If any damage is found, contact the shipper immediately
and file a freight claim. Norton Clipper is not responsible for any freight-related
damages. Remove the saw from the pallet. Reverse the position of the
handlebars so that the handle bar sticks out towards the operator. Adjust the
handlebars to the desired height. Align the hole located in the operator's right
side of the Handle Bar Assembly with the M10 Weld Nut in the frame. Attach
the handlebars to the saw with the supplied hardware. The Operator's Right
Side Screw part# 028098 will pass through a hole in the Handle Bar Assembly.
Tighten 029098 to the Handle Bar Assembly and then tighten the M10 Jam Nut
027006. Tighten 027021 to the Handle Bar Assembly and then tighten the
M10 Jam Nut 027006. Read and understand the remaining sections of this
Owners Manual. NOTE: Do not install the blade until it is time to use the saw.
ANSI regulations prohibit the transportation of any concrete saw with the blade
installed.
DO NOT LIFT THE SAW BY THE HANDLE BARS
027006
027021
Part #
027021
028098
027006
028098
Screw DIN931 M10 x 25 Hex Head Cap
Screw DIN933 M10 x 65 Hex Head Cap
M10 Jam Nut DIN934
7
M10 Weld
Nut
027006
Description QTY
1
1
2