App. 5 Compliance With The Ce Marking - Mitsubishi Electric MELSERVO-J3 Series Instruction Manual

APPENDIX

App. 5 Compliance with the CE marking

App. 5.1 What are CE marking?
The CE marking is mandatory and must be affixed to specific products placed on the European Union. When a
product conforms to the requirements, the CE marking must be affixed to the product. The CE marking also
applies to machines and equipment incorporating servos.
(1) EMC directive
The EMC directive applies to the servo units alone. This servo is designed to comply with the EMC directive.
The EMC directive also applies the servo-incorporated machines and equipment. This requires the EMC
filters to be used with the servo-incorporated machines and equipment to comply with the EMC directive.
For specific EMC directive conforming methods, refer to the EMC Installation Guidelines (IB(NA)67310).
(2) Low voltage directive
The low voltage directive applies also to servo units alone. This servo is designed to comply with the low
voltage directive.
App. 5.2 For compliance
Be sure to perform an appearance inspection of every unit before installation. In addition, have a final
performance inspection on the entire machine/system, and keep the inspection record.
(1) Servo amplifiers and direct drive motors used
Use the servo amplifiers and direct drive motors which standard product.
Servo amplifier
Direct drive motor
Note. For the latest information, contact your local sales office.
: MR-J3-20B-RJ080W to MR-J3-100B-RJ080W MR-J3-500B-RJ080W
: TM-RFM C20 (Note)
TM-RFM E20 (Note)
TM-RFM G20 (Note)
TM-RFM J10 (Note)
App. - 6