Factory Settings - Panasonic LS-400 Series Operation Manual

Operation protection
You can use the 'key lock function' to protect these operations. (Refer to p. 56.)
Key lock function
This function can be used to prevent the operator from accidentally changing the sensor settings.
Output switching
Set the sensing mode (PRO6) for output 1 to normal mode beforehand.
In modes other than normal mode, this is fixed at output 1.
Press the MODE key for more than 2 seconds when in NAVI mode. If Output 1
has been selected, the Select 1 indicator (yellow) lights up. If Output 2 is being
selected, the Select 2 indicator (yellow) lights up.
Automatic interference prevention function
To operate the automatic interference prevention function, you need to install the amplifiers so that they are
directed against each other and carry out optical communication.
The automatic interference prevention function allows up to four sensor heads to be installed so that they are
directed against each other.
(However, the automatic interference prevention function cannot be used in H-SP mode.)

3-2. Factory Settings

Factory settings for the LS-400 series are indicated below:
If the amplifier is reset using the '9-4 Setting Reset Function' from 'PRO5 Mode' on p. 50, the resulting settings
will be those indicated below:
NAVI mode
CUSTOM mode display
PRO mode
Amount of shift during limit teaching
Selection for transmission change to permit / not to permit
External input switch setting (Note)
Backup setting (Note)
Output 1 / 2 sensing mode
Note: Equipped with cable type only.
Ramco National
Item
Threshold value
Output operation
Timer operation
Item
Response time
Hysteresis
M.G.S.
Emission halt
Display switching
Display turning
ECO mode
Period hold
Code setting
0-adjust setting
(800) 280-6933
Settings
Output 1: 40, Output 2: 60
L-ON L-ON (Output 1 Output 2)
Without timer (Output 1 Output 2)
Response time change
Settings
STD (standard)
H-02 (standard)
15 %
Level 3
Laser emission ON
Incident light intensity display only
Digital display turning OFF
ECO OFF
Hold OFF
Lock OFF
Emission halt
OFF
00000000
OFF
Normal mode
4
Select 1 indicator Select 2 indicator
(Yellow) (Yellow)
Digital display
Output 1: , Output 2:
Digital display
www.pansonicsensors.com