INVT SPC Series Operation Manual page 43

SPC Series Solar Pump Inverter
Function
code
User-defined
P14.07
User-defined
P14.08
P14.10
Boot software
P14.11
Name Description
1: Password protection is valid.
Hundreds place: User-defined
communication command address
0: Invalid
1: Valid
The hundreds place of P14.06 is used to
define whether a user-defined address is
valid. The value 0 indicates the standard
communication mode is used, while the
value 1 indicates a user-defined
communication address is supported. A
user-defined communication address
takes priority. Supported user-defined
addresses are P14.07 (Run command)
and P14.08 (Frequency giving). You can
set the address according to the type of
inverter that will be replaced.
address for
0x0000–0xFFFF
running
commands
address for
0x0000–0xFFFF
frequency
setting
0: Disable
1: Enable
Only when this parameter is set to 1
Enabling (Enable), P14.01 is automatically
upgrade updated to 6, and the RMS module can
upgrade the firmware.
Note: Firmware upgrade requires that the
machine is not in running state.
1.00–9.99
version
-39-
Function parameter list
Default Modify
○
0x1000
○
0x2000
◎
0
●