Table of Contents
Advertisement
GAA610-M ADVANCED EMISSION GAS MONITORING SYSTEM | OI/GAA610-M-EN REV. B
Storing the device
Bear the following points in mind when storing devices:
•
Store the device in its original packaging in a dry and
dust-free location.
•
Observe the permitted ambient conditions for transport
and storage.
•
Avoid storing the device in direct sunlight.
•
In principle, the devices may be stored for an unlimited
period. However, the warranty conditions stipulated in
the order confirmation of the supplier apply.
Ambient conditions
Ambient temperature during transport / storage
•
2 to 60 °C (35.6 to 140 °F);
•
−20 to 70 °C (−4 to 158 °F) after draining and drying parts
in contact with condensate.
Max. permissible humidity
Year-round average max. 75%, short-term max. 95%,
occasional slight condensation is permitted.
Packaging
1. If the original packing material is no longer available, wrap
the device in bubble foil or corrugated cardboard.
When shipping overseas, also heat-seal the device air-tight in
0.2 mm thick polyethylene, including a desiccant (e.g. silica
gel). The amount of desiccant used should be adequate for
the package volume and the probable shipping time (at least
3 months).
2. Pack the device in an adequately large box lined with shock
absorbent material (e.g. foam material). The thickness of the
cushioning material should be adequate for the weight of the
device and the mode of shipping. The box should also be
lined with a double layer of bitumen paper for overseas
shipping.
3. Mark the box 'Fragile! Handle with care!'.
Returning devices
Use the original packaging or a secure transport container of an
appropriate type if you need to return the device for repair or
recalibration purposes.
Fill out the return form (see Return form on page 99) and include
this with the device.
In accordance with the EU Directive governing hazardous
materials, the owner of hazardous waste is responsible for its
disposal or must observe the following regulations for shipping
purposes:
All devices delivered to ABB must be free from any hazardous
materials (acids, alkalis, solvents, etc.).
Address for the return:
Contact Center
www.abb.com/contacts
17
Advertisement
Table of Contents
